Originally Posted by
GizmoTLR
I ran 81/20 with temps around 130 just fine. Perhaps your gear mesh could be a little too tight? Or possibly too much drag brake? I dont think a slipper setting could cause over heating but just in case heres how i set my slipper...
Put a hex wrench in the adjustment hole, pick up the rear end so tires are off the ground, apply small pressure to the front and roll the car until the front tires just start to skip. And if its still a little too loose for the track condition then i do the same but with the rear end on the ground and front raised up. I also run no drag brake.
uhh my gear mesh is perfect. No drag brake, my braking is set at 90% tho when I brake.
I tried doing that method to set the slipper but failed cuz my slipper is fairly new so the spring is very stiff, I had to set it at 3mm and use a clamp to put my slipper together.