Originally Posted by
teknorc
Correct. This part was based off of the BMI LRC inserts. The only issue with the inserts were not enough material around the hinge pin and only center dot was available. So with the new LRC block, you use the stock inserts and have full adjustability. You can use the BMI inserts in conjunction with the LRC block and get it really low.
Yes the stock horn works great, until you take it off and on a bunch of times. Gets a little loose on the servo then. No problem though I will just make sure I have a spare set of plastic ones on hand.
The pills do the same thing but I went through this with my AE car and a new toe block is a much easier solution. It's not cheaper up front but it allows you to use the inexpensive pills instead of having to buy the Low RC inserts in all the different dots.
Yes Danny you could combine this with the LRC insets but it gives a ton of anti squat at that point without a lower anti squat plate. A bunch of anti squat along with the LRC is usually counterproductive . At least it was on the AE car. Maybe the tekno would react better.
For people planning on using this it also changes your anti squat so if you have a setting you like you will need to drop it one dot along with the plate.