I am having problems programing mine. I have 06.1 firmware on it. I have a wraith with mechanical dig (3 position operated by a servo) and I am wanting to set it up for 4WS

This is my current setup n the CH3 trim
reverse LONG
3 CH3 BNL 100v REo ORo

I want to have a 3 position switch on the dual rate switch to operate the choice between FWS, 4WS, RWS. And then have a 2 way switch on the 3rd channel button that cycles between Crab steer and normal 4WS.

I was going to use this setup:

E. point LONG
ch 4 enter 3 0% CR zero LONG

Rev LONG
3 4WS BM zer0 RE zer0 PV zero
C 4WS MO zero RE zero PV zero v OFF LONG

Can someone help me modify the DIG setup so that I can have both?

Thank You