Originally Posted by
mashimarowu
Anyone know of an easy way to set the slipper? The spring is so stiff that its hard for me to screw the nut any further.
remove the slipper from the car.
Take the spring and compress it flat with a pair of pliers.while your compressing the spring coat the threaded shaft with blue Lock Tight and let dry.
reassemble with about 1/4 in of thread showing past the slipper nut.
Install inside car , can readjust the slipper with a 5/64 driver by sticking it inside the hole in the side of slipper nut.
If you are using brand new pads ?
Will need to break them in a pack or two ,then readjust the slipper to get good acceleration with out it being locked up tight.