Originally Posted by
inpuressa
Did you crank the endbell past the factory markings? For the TX motor you need to go 2-2.5mm past the last advance mark to get into the sweet spot. There is also a 12.3 and 12.5 rotor too. But with the limited gearing on the mini, you may need to experiment. Maybe that other guy is using some aftermarket high speed gear set?
BTW its TCS legal...
The fast guy is on all TCS legal stuff and does not have high speed gear set...
i cranked the motor to 2mm above the + and it was kind of hot... 156 degrees... still was not close... so i thought that was meant for top end... so i brought down the timing to the middle mark.... still not luck...