Originally Posted by
teknorc
You might need to rotate the carb ball down. Tilt the ball toward rear of car for front engine, tilt toward front of car for rear engine. I think that is what is causing your issue. If the linkage isn't straight after you rotate the ball, then you may need to also rotate your carb per the manual. Give that a shot and let us know if that solves it. Thanks.
Thanks. After a lot of trial and error, I think I finally found the sweet spot for this motor. I can't get the carb really in a straight line and clearance is only about 3.5mm, but it's better than I had. Any more to the left and I don't have enough clearance. Any more to the right and it's right at the filter.
