Originally Posted by
RokleM
Thanks, no doubt you have more clearance. I double checked the manual and it appears to be all assembled and setup right for the engine in a rear position. I've tried the link to the right down lower and the linkages rub and are close to the foam. Here I have it to the left in a straight fashion with the carb. If I rotate it counter clockwise it will no longer be aligned and will rub with the servo horn slightly.
Based on the amount of space you have, I must be doing something wrong, but I'm not seeing what it is.
Engine is a werks b6 for what it's worth if somehow something is different there.
You might need to rotate the carb ball down. Tilt the ball toward rear of car for front engine, tilt toward front of car for rear engine. I think that is what is causing your issue. If the linkage isn't straight after you rotate the ball, then you may need to also rotate your carb per the manual. Give that a shot and let us know if that solves it. Thanks.