finally got my scte fully cleaned and running
but the sr300 in it is very very glitchy.

when only the esc is plugged in, there's no problem. but as soon as I plug in the servo (d226f if it matters) the esc and steering are very very laggy and unresponsive. The steering is constantly twitching even with no tx input, and at full lock to the left it's intermittent. as in, it will go full lock, back to center, then back to full lock over and over. full lock to the right it doesn't do that, but it only pick up the signal half the time, and and my throttle control is pretty much gone.

I plugged everything in to my el-super-cheapo FS rx and everything was great.
I'm sure my dx3e and sr300 are supposed to be much better than my gt2 and gr3e, but right now it's not seeming like it.