I have a newbie question. I have searched the internet and looked at youtube videos but can't find an answer.
I recently attempted to rebuild by Ball Diff, it appears to be too loose since I am getting zero punch when trying to accelerate and there is a funny noise when applying the throttle. It is the same noise and issues that I was experiencing before I rebuilt the ball diff (there was a washer exploded on the thrust bearings).
Anyways my question is about the turnbuckles, is there an easier way of removing them (i.e. popping them off) instead of unscrewing them from the rear hubs? I am just trying to find quicker ways to remove the transmission and gain access to the ball diff. Right now I am pretty much taking the entire back end apart.
Thanks,