Originally Posted by
SPOT MY 6
Having trouble with a rx8gen2 I bought from a board member. I have a 3pk super and set the profile to factory defaults. Also set the RX8 to factory defaults. When in setup mode, it never detects neutral.
- the esc is connected to the rx properly
- good solid and proper solder connections
- tx battery is full
- servo works fine
- rx works fine in another car
- tried changing throttle on tx to reverse
- sensor wire is new
When NOT in setup mode, the ESC lights change when pulling throttle or brake, so it appears to be getting signal from the RX. Also the fan comes on as soon as it turns on. Not sure if that's normal.
I read about neutral width being a problem but don't see that in my 3pks or the manual. Am I missing something else?
Thanks
I fixed the problem by messing with my 3pks. I had to go into adjustments > throttle and reset the neutral, fwd, and brake values. Once that was done, setup mode found neutral and fwd, but not brakes. I then went into the 3pks and set throttle to reverse and then it worked. Hopefully this helps someone else with a 3pks.