Originally Posted by
Granpa
If you're talking about the wheel bearings, they are 1050. This should not be a problem as you would not have been able to assemble with 1150 bearings. The old style M03 uprights used the 1150.
Could you check this????? From the symptoms, it almost sounds as if you're using the splined outdrives from a gear diff. The splines on a Ball diff outdrive is a bit shorter. I have seen people do this before.
The reason I gave the 1150 bearing number is that is what is listed in the manual. I have no way of knowing if that's antiquated or truth because there isn't anything printed on the bags.
Here's a pic of what I was talking about. I think I see why they don't fit.
Where the axle meets the bearing appears to be a millimeter or two longer than the stock one. Is the V2 kit somehow different? I just can't see that.