Originally Posted by
Granpa
Sorry, but didn't pay much attention. Eric posts on this thread as EricP. Since I brought it up, he may post it or you could send him a PM. I think Eric builds a lot of the display or show models for Tamiya. I just commented on it cause it was such a "clean" solution.
I do build some pretty nice stuff... "toot toot"..?
The TT-01R kits come with a 5x8mm plate (#9808007) which are also used for it's droop screw setup. I used some spares. Now, with that said, they needed to be cut in half for the front. There is a small space for the front droop screws so pretty much anything will need to be cut. Scraped the coating from the chassis and used 5 minute epoxy to secure - works fine.
Someone posted a link for droop screw mounts - those would work, but probably will need to be cut as well.