R/C Tech Forums - View Single Post - Official Tekin RX8 GEN2 ESC Thread
Thread: Official Tekin RX8 GEN2 ESC Thread
View Single Post
Old 06-06-2014 | 10:50 AM
  #2245  
Randy_Pike's Avatar
Randy_Pike
Team Tekin
iTrader: (6)
 
Joined: Nov 2007
Posts: 9,912
From: Norcal
Default
Originally Posted by sn47som1
I just had a guy at the hobby shop solder an rx8 gen 2 to my brushless sensored motor. i told him to solder the corresponding letters to each other a, b, c. But he soldered a to c and c to a. I havent turned the system on yet or anything. Could I run in reverse mode in the ESC?
Nope, take it back and have it wired correctly or you can damage it.

You could temporarily remove the sensor harness completely and run it sensorless.
Randy_Pike is offline  
Reply