Hey guys,

I have my kit built as far as I can go with it until my motor and ESC arrive this week. Went together really nice except for the shims when installing the front and rear difs into the cases. I wish I had gone back and read page one again as I bent a couple of them pretty bad trying to get them in place.

Did anyone find that a few of the screws with smaller heads were were machined off a bit, allowing a lot of play around your allen head driver? I don't remember exactly but it seems like the ones I had a problem with were 2mm for the driver.

I'm using an old set of Losi drivers and they all seemed to fit perfectly when I built my Associated buggy a month ago.