Originally Posted by Casketman

So I dont know about others but Ive had an issue with some of the stock screws. Mainly the 3x40 screws used for the hinge pin blocks on the bulkheads.

Even with a band new VP Pro 2.0 bit,it still skips out and is right on the edge of being stripped. As if the hex bit hole isn't deep enough for the bit to sit down in like other screws.
So I decided to change those out and do something different before I do strip the screw head.
I went to Amainhobbies.com and picked up some Protek 3x40 cap screws and some Lynx Heli countersunk washers.

The end result doesn't look bad or as if it wasn't stock(in my opinion). But mainly,no more chances of stripping a screw.