Originally Posted by
Juan Aveytia
Kentech or red bull. Both of you seem to have lots of knowledge with Tamiya's and other stuff. I want to buy a floating servo mount for my 414. The Tamiya 503 has some parts that I think will work perfectly for me. Could either one of you help with the correct part numbers to from this car. I need everything to make the floating servo mount and split battery pack holders. All help is appreciated
Here's some info:
- 9114087 J Parts (you need 2 of these)
These are the battery holder plastic parts tree, so it has the locators that go on the lower deck as well asthe plastic hold downs.
- 9804800 Battery Post (you need 4 of these if you want to use posts and a hold downs instead of tape)
Servo mount:
- 3404035 Servo Mount Bridge
This is the carbon part of the 503 servo mount.
- 3454971 Servo Mount
The inner alu post (keyed both top and bottom, 2 screws that go into lower deck)
- 51278 TRF501X K Parts (Bearing Holder)
Just the normal 501 plastic servo mounts that are used at the outer end with this solution.
Hope that's the info you needed. Of course you need some normal screws, shims etc. too.
Attach manual pics of the parts needed: