Originally Posted by
nf_ekt
Dremel. You have to go to work on the chassis and also remove a bit of material so that the motor cam (?) can rotate enough to get the mesh correct. I couldn't get any sort of realistic gearing fitted at first. Once I looked at what was preventing this I just got to work on a little cutting and grinding. I also cut down the rear chassis braces trying to get a bit more flex. I could clean the area a little more but you get the point. I can throw just about any FDR i want at it now.
Nice!
I have some modding to do to the tc3,was thinking of dremeling out the webbing in the center of the chassis just under the driveshaft. I've seen that done and looks good also gives a little more flex.