Originally Posted by Tekin Prez

If your RX8gen2 unit flashes leds 1,4,7 please send it in for repair.

When the unit temp is around 3 leds it will start flashing leds 1,4,7. This may happen a few times and reset or in some cases continue this loop until the unit is turned off and back on.

There is simply a misloaded component on the control board causing this condition.

We apologize to those few that have gotten these units. We caught the mistake pretty early, but some units did get out the door before we were aware of it.

Please make sure the unit is not actually flashing 1,3,5 indicating voltage cutoff. Again this error code will typically show up about 3 min into a run when the unit gets to about 3leds of temp.

Please fill out the service form on our website and include it with the unit. Clearly mark that it is a 1,4,7 error code and we will fix it up and get it back to you quickly.

Thank you for understanding. Things happen.... All we can do is react quickly and make it right so everyone can get back to Racin!

Jim Campbell
President
Tekin, Inc.