R/C Tech Forums - View Single Post - The Speed Passion Thread
Thread: The Speed Passion Thread
View Single Post
Old 05-14-2014 | 08:24 AM
  #12582  
Solara
Tech Champion
iTrader: (17)
 
Joined: Sep 2002
Posts: 9,295
From: Chicago Illinois USA
Default
Originally Posted by MX304
I just picked up a Reventon 1.1 ex and LCD programming card. For some reason I cannot get the card to communicate with the esc. It powers up and I get a screen showing the firmware revision, but none of the buttons work. I downloaded the PC interface and when I try to use it, the screen keeps telling me to connect the esc even though it already is. The esc synced with the rx just fine and everything works, I just can't change any settings. Any ideas?
Please go thru the USB setup, there is a folder about USB and you have to install that. Your case is your CARD is not connecting to the computer because the USB driver was not installed.
Solara is offline  
Reply