here it is in the car at last.

I wouldn't be me I didn't notice something however and unfortunately I have.

Have a look at how Keyence have attached the wires to the Esc, I notice how little an amount of wire actually seems to be soldered onto the tabs (most easily seen on the green wire).

I've never had one of these Esc before so I wouldn't know if it's enough to hold or put up with any movement the plugs might make as motor/battery are unplugged/plugged back in?

Dragonfire: You can also see in this picture what I emailed you about with regards the motor leads having to do a 180.

Edit: I also found a way to keep that bit of display screen plastic on as well. In the end I got an off-cut from the Speedtech RC sticker sheet (which appears to be vinyl) and stuck it over the top). I didn't have any ca at the time Adrian.