View Single Post
Old 05-07-2014, 05:25 AM
 
PW
Tech Elite
 
PW's Avatar
 
Join Date: Sep 2001
Location: Groveland, FL
Posts: 4,498
Default

Originally Posted by blvdbuzzard View Post
I just put this kit on my SC10.2 Everything fit pretty well. No real problems with the install. I will try it out tomorrow at the track and report back on how well it does.

I do have to say I had to replace the (4) set screws in the aluminum ends. My metric hex wrench would not fit, nor would my standard. First time I tried ti tighten the screw, it stripped. Had to slot it to get it out. Are they some special size?


Buzz.

http://www.jconcepts.net/store/index...roducts_id=696
It's not metric; it's standard .050" I just checked a new kit and my .050 wrench fit nice and tight. Maybe some bad set-screws or your .050 tip is slightly undersized or rounded.
PW is offline  
Reply With Quote