Originally Posted by Kraig

I ran 37.5 front and 30 rear with 5 holes this past weekend at the Shortcourse Showdown. I wish I changed it by going up 2.5 front and rear or change the piston's to 4 hole to get more pack. There was one jump in front of the drivers stand, to a table top landing area, that required you to get a long run to clear the gap. I think either one of those changes would have helped.

Overall, I finished building the truck at the track on Friday and got two practice runs with it by the end of the day. I ended up qualifying 7th out of 40+ trucks and finished 4th in the 7 minute main. My times were right there with the leaders but I was not consistent enough.

I will post my setup in a day or two but my electronic layout is as follows, servo, receiver, square pack, speed control running rear motor. With that layout and a Pro-Line body, with a lot of paint on it, I was 100 grams overweight.