Hello mr4-tc sp,

>1. The charger is able to monitor the cell individually while
>charging. Does it have any special handling on a battery pack
>when it found one of the cell is not in good condition? Or it just
>figure out to which cell is the weak one.

In the usual charge, the data of individual cell is only collected.


>2. Is there any different on Peak detection between with and
>without remote lead attached.

There is no difference. Charge is controlled by any case by fallback of battery pack.


>3. With temperature detection module attach, I have to set the
>safity delta to pretty high to prevent false peak. For example
>0.2v which is a lot more than what I have set on peak detect
>charge. Would you pls. advise why??

As far as I know, the method of battery pack voltage detection is the same also at Peak or Temp. However, Discharge B4 Charge is not made in Temp. Therefore, it is thought that Lockout is not used. I know that it will be easy to generate false peak in early stages of charge in old pack. My pack has not encountered such a problem.



>4 When using S.A.L functions with the Pro-trak monitor program,
> will all the cycles information be recorded automatically?

If it is made a setup which sends SAL Parameter, it is saved at EVENTS column. SAL-->SAL Options-->Send Header
** In PRO-TRAK distributed in the USA, it is a name of CDAT. The contents are completely the same only by a name being different, as for SAL and CDAT.



>5. What needed if I upgrade a version 7 pro-trak to 10.72 except
>modifying the circult board and remote lead socket?

It is necessary to re-enter calibration data. If you have data sheet, it will be the work finished with 1 minute.