Originally posted by mario
Usually I do not comment any posts on other forums, but I can not resist this one.
Can you please let me know how did you come up with this? If you from any reason preffer some other than XRAY' original XRC chassis, it is of course your free choice, but PLEASE, do not spread rumors which are not true.
To keep the things correct and not to mislead anybody - there is NO glitching just because of XRC chassis and the possibility to get glitching on the XRC is the same possibility like to get it on any other chassis.
If anybody has any concerns or additional questions, please feel free to visit the XRAY's customer support forum at www.teamxray.com/xforum where XRAY's support staff and XRAY's team drivers answer any technical and other related questions.
If you read quite a few pages back, Jason from BMI stated that running a chassis with a large area in which the center of the graphite it exposed can cause interference especially with cheaper radio gear. That is why BMI doesn't mill down the area under the servo since lowering it 0.5mm doesn't make a noticeable differance compared to the cost of possible glitching.