R/C Tech Forums - View Single Post - Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
Thread: Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
View Single Post
Old 04-19-2014, 06:43 AM
  #3679  
langsky
Tech Regular
iTrader: (27)
 
Join Date: Aug 2013
Location: Michigan
Posts: 486
Trader Rating: 27 (100%+)
Default
Originally Posted by mdowney
Quick tip for anyone using the 3x8mm set screws in the front caster blocks (which eliminates most of the slop): those little screws strip VERY easily so don't over-tighten and back them out very carefully. If they strip you'll never get that caster block off the hinge pin in one piece. You'll be hacking away at it with the Dremel like I just did.
Good tip...you can use one of the longer M3 BHCS screws from the kit to thread the holes first.
langsky is offline  
Reply