R/C Tech Forums - View Single Post - Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
Thread: Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
View Single Post
Old 04-19-2014, 06:39 AM
  #3678  
racer_guy
Tech Adept
iTrader: (5)
 
racer_guy's Avatar
 
Join Date: Jun 2011
Location: Spokane, WA
Posts: 248
Trader Rating: 5 (100%+)
Default
Originally Posted by mdowney
Quick tip for anyone using the 3x8mm set screws in the front caster blocks (which eliminates most of the slop): those little screws strip VERY easily so don't over-tighten and back them out very carefully. If they strip you'll never get that caster block off the hinge pin in one piece. You'll be hacking away at it with the Dremel like I just did.
good lookin out!! so is it worth getting them as far as getting the job done is concerned?
racer_guy is offline  
Reply