R/C Tech Forums - View Single Post - Spec-R R1
Thread: Spec-R R1
View Single Post
Old 04-09-2014, 05:26 AM
  #2860  
PEEKracing
Tech Initiate
 
PEEKracing's Avatar
 
Join Date: Dec 2013
Location: Montreal
Posts: 45
Default

Originally Posted by valk
Ps. Dunno if its mebtion you also need additional rod ebds for swaybars. Good time to get tamiya ones. Use tamiya for all steering links and upper arms, stock for swaybars.
I think the manual specifies how long to make all the rods and you will have to compensate the difference in the tamiya ends.
There is a table to set toes with the inserts but is there a relation table comparing it to trackwidths? Would be nice to leave the steering links alone and adjust toe with inserts only.
I've not seen such a table, but I was thinking about making one, though time I have not.

As for adjusting front toe only with inserts I'm not sure that would work, as adding toe-in will swing the wheel end forward, thus pulling on the steering links and removing toe-in. Vice versa for toe out. However, the change may not be so great as to be measurable, I've not done the geometry.
PEEKracing is offline