Originally Posted by
ANGRYEVO8
So far on my X3 GT i have completed the following mods
Rear 7075 axle carriers
Front 7075 lower hinge pin mounts and inserts
Front lower captured hing pins
7075 chassis braces front and rear
7075 castor blocks
I have put bearings instead of bushes in the steering
I will try and put bearings in the steering ackerman plate today
just a little update to those who have installed the front lower hinge pin mounts. the plastic tab to mount bumper, intended to slip in between the gearbox assembly and chassis is a little thick.
i notice that there is a slight difference in the recess hole between the 7075 alu mounts and the stock ones. i think some shaving is needed to the top of the plastic tab so that the hinge pin mount sits properly.