Originally Posted by 8ight-e

Not that it matters as stated; but I have the tekin 1350 w/ hw 150a esc on 6s

I'm running red CSI - running 40wt front stock spring 35wt rear Yellow spring (im sure tekno has the rates listed somewhere)

118 front measurement (center screws t/b) shocks center lower position, #3 top

130 rear measurement (center screws t/b) shocks center lower position, #3 top

Mostly the kit setup I think on bump steer/ackerman; 2over 2 under large side up on ballstud. 4washers over, ballstud down

Stock 2.6 sway bars but I do have a rate lower to swap on if needed

Diff's I like 10/15/5 best but depending on track you may want 10/10/5, with good bite 15/20/7 also is very nice.