Originally Posted by
Cadman1981
Which springs fit? Can someone measure the diameter and length so i can compare them to what i have (yokomo, tamiya and HPIs)
Not at the bench at the moment, but any of the springs that are in the 23mm height range will work, I have run original long Xray springs without issue and I know they are similar to the Yokomo springs, maybe slightly smaller diameter but will still work. So I would think your Tamiya and HPI springs should work as well, or anything that was used on a "normal" long shock, pre-short shock era. It is not what I would consider a "big bore" shock either.