R/C Tech Forums - View Single Post - Kyosho Plazma Formula 1
Thread: Kyosho Plazma Formula 1
View Single Post
Old 03-18-2014, 11:02 PM
  #102  
JLock
Tech Elite
iTrader: (4)
 
JLock's Avatar
 
Join Date: Nov 2001
Location: North Dallas, TX
Posts: 4,520
Trader Rating: 4 (100%+)
Default
Originally Posted by QIMB528
Yes I did, Had a club race last Sat and at the end of the day, I did an intentional crash at 3/4 of full speed.

It did not break. The pictures were taken after the crash.

Also, because it had shorter width, I had to change the adjuster rods to 1/12 plazma's rods. KYO92414 - Kyosho 42mm Titanium Adjuster Rod
So, when you are going to produce these pieces for the market and how much will you be asking for the arm set?
JLock is offline  
Reply