Originally Posted by
daxbrandy
Mix and Dusty
Salamat sa inyo. Well, in theory the panhard should work. :-) masasabi ko greatly reduced ang bump steer. It got me busy yesterday sa shop. Sa likod kaya needed pa rin panhard?
With regards dun sa spokes, i have to reduce the diameter first before threading it. 3.3mm yata ang OD ng spokes. Sa lathe po ginawa ang reduction para pantay ang bilog. Need at least 2.85mm para maipasok ang die.
Yung shock naman, brand new po yun. :-( check ko laters pag tapos ko na body mount
Ganda po ng DIY nyo.
May I suggest lang , after many hours of mileage sa SCX10 ko, you might want to consider revising that Shock Mount to have multiple Holes for finetuning Shock height at kung kaya pa extend rearwards para ma anggulo ang Shocks.
After some point in time, you might realize that the vertical shock placement has still room for improvement if adjusted by height and most probably by Angle ( recline, incline ) which will affect crawlability over obstacles.
Again, Ganda po ng output ninyo Sir.