Production version spurs!

on the truck (excuse the dirt!!)



Some other info, Over the past year i have been making mod1 spur gears for on road 1/8 scale nitro. I finally pretty much perfected the tooth profile and the spurs literally never go bad and if any of you run GT you know what i am talking about! You have to have the mesh gap very small and actually touch in order to make a hour long main. I adapted this profile to the SC10 so its much easier to set your mesh and forget about it, another side effect to this is that it is very quiet relative to normal MOd1 profile. so instead of setting your gap to the insides of the teeth you set it to the bottom, in between the teeth which is rounded.