R/C Tech Forums - View Single Post - How to reduce noise in a detection loop
Thread: How to reduce noise in a detection loop
View Single Post
Old 03-03-2014 | 03:42 PM
  #4  
Bob Malphurs's Avatar
Bob Malphurs
Tech Master
 
Joined: May 2005
Posts: 1,162
From: Monroe, GA USA
Default
Originally Posted by Only Fine Helis
Thanks for the tip.

Do you put a resistor in the middle of the loop, or is it just a single strand looped?

Thanks again,
Shannon
Should have a 470 ohm .5 watt resistor (Radio Shack)! I use 18 gauge speaker wire with no problems. There is always an increase in noise at night
Bob Malphurs is offline  
Reply