Originally Posted by marek_k

I observed that my ESC shows HIGH neutral signal (leds 5,6,7) when in Lipo cut off. I am not sure when it started, when it was new it showed correct combination. I took closer look at it, when it reaches lipo cut of it shuts down car with leds 1 3 and 5 blinking for a 1 second and then it immediately shows 5,6,7 and stays there. ESC is properly calibrated. Besides this strange leds behaviour everything works fine.

lupalra - isn't just your lipo cut off set way to high?

Randy_Pike - any possible explanation why lipo cut off switch leds to 5,6 and 7 . Is it normal?

And Randy, AFAIK you should be getting some information about interest in building WP brushless sensored ESC combo. Yes we want it!!