Originally Posted by
PYRO689
Hi all,
Building the shocks for the first time and having a little issue. front shocks no issue, but when building back shocks after bleeding them I get very little rebound (shaft pushing out from shock) which is normal....but when I extend the shock shaft it sucks back up into shock almost all the way....I don't believe this is correct as the fronts did not do this.....
I have refilled and bled a few times with same results.....can someone chime in on what I could be doing wrong or explain the procedure for building the shocks?
Thanks
Ken
In regards to the O rings in the top cap
I was reading the build notes and it mentions you can you use either the ones that go up in the cap, or the ones that go on the threads.
Is one better then the other, or just personal preference. I built with both (read the notes afterwards) and curious if that could be causing my issue. I will find out tonite......anyone run both?
ken