I did a count on hardware for the B5 going through the manual and figured I'd share if anyone is looking to put their spare parts in order as well. I did notice a couple of the screws listed on the hardware page are not used for the RM kit so I assume they're shown due to their use in the MM kit.
NOTE: I included all the optional set screws on the suspension and only accounted for ball shims as the stock setup shows. Shock rings, spacers, seals etc. are not accounted for here at this time as well. E-clips i did count since they were shown on the hardware page.
(qty) description (AE part #)
Button Head Screws (BHCS)
(10) 2x4mm (31510)
(2) 2.5x6mm (31520)
(3) 2.5x8mm (31521)
(0) 3x4mm (91158)
(4) 3x5mm (31530)
(0) 3x6mm (31531)
(12) 3x8mm (31532)
(6) 3x10mm (25211)
(12) 3x12mm (89202)
(4) 3x14mm (25187)
(5) 3x16mm (89203)
(0) 3x18mm (2308)
(4) 3x22mm (25189)
(4) 3x24mm (89204)
(1) 3x30mm (91478)
(1) Diff Thrust Bolt (6573)
Flat Head Screws (FHCS)
(1) 3x8mm (25201)
(5) 3x10mm (25202)
(4) 3x12mm (25203)
(2) 3x14mm (89208)
(4) 3x16mm (25204)
HD Ballstuds
(6) HD 6mm (91047)
(2) HD 8mm (91048)
(6) HD 10mm (91049)
(0) HD 12mm (91050)
Shims & Washers
(4) Servo Mount Washer (7337)
(.250 x .125 x .815)
Ballstud Washers (31286, 4 each in pack)
(1) 1mm Aluminum (servo arm)
(6) 2mm Blue
Nuts
(4) M3 Nut (91477) - black
(8) M3 Locknut w/Flange (25612) - black
(5) M4 Locknut w/Flange (91148) – black
Set Screws
(1) 3x3mm (25225) Antenna Tube
(6) 3x8mm (4670)
(2) 3x16mm (4689) Battery Hold Downs
Bearings
(8) 3x7x3mm (91475)
(2) 5x8mm (31400)
(4) 5x10x4mm (25237)
(2) 6x12x4mm (25238)
(2) 6x13x5 (91476)
(4) 10x15x4 (25616)
Clips
(8) E-clip 1/8 (6299)
Diff Balls
(6) 5/64 Diff Thrust Balls (6574)
(14) 3/32 Carbide Diff Balls (6581)