View Single Post
Old 02-24-2014, 04:51 AM
Tech Master
iTrader: (30)
maddog9's Avatar
Join Date: Sep 2011
Location: Columbus, Ohio
Posts: 1,294
Trader Rating: 30 (100%+)

Originally Posted by nEoNidas View Post
Just about finished my build, planning on using the dunsford set up. I got an rx8 gen 2 and looking to hook it up to Tekin sc4 550 4.5 or thunder power 550 4.5. What kind of timing do I have to do to get this baby humming? Do I go with a 12t or higher for pinion? Plan on doing most of my racing at Hot Rods. I have put 5/5/3 in the diggs, what's recommended for shock oil? And any other tips u can throw in there, I'd most appreciate. U guys rock, the rc community is like no other. Thanks in advance.
Tekin suggested turning the can timing to zero and then run timing profile 4. Depending on your track size probably a 12 or 13. Shock oils i would run #3 pistons all the way around with 30 front 25 rear. Then dunford setup uses 575 the latest one does. If your building the kit do not use the kit oils as they are not correct.
maddog9 is offline  
Reply With Quote