R/C Tech Forums - View Single Post - Fed up with brown outs
Thread: Fed up with brown outs
View Single Post
Old 02-20-2014 | 11:21 AM
  #17  
zixxerluv's Avatar
zixxerluv
Tech Apprentice
iTrader: (1)
 
Joined: Jan 2014
Posts: 56
From: Gardner, Ks
Default
Originally Posted by ufoDziner
You're not using the MMP's BEC, so the MMP BEC issue doesn't matter. Also, per your description, it's the motor that is what is consuming the power in this case.
Tips on motor setting? I have left it at stock settings as this seems to be the fastest.

As for solder connections involving the BEC, I bet I could do a better job. Looks like a I have more solder than necessary. I'm thinking I should probably solder the BEC wires to the tabs first, then solder the ESC wires to the tabs.

I set the MMP to 6volts on the BEC. Also, for what it's worth, I'm going to replace the SR3001 Pro with my extra Spektrum SR3000 receiver.
I just want to try everything before I get off my wallet and put in for a sweet new HiTech servo, and perhaps a new Rx/Tx module or whole new control setup.
Unfortunately, I won't get to test any of these changes until Saturday at the latest.
zixxerluv is offline  
Reply