Originally Posted by
Velocitygt
Hi guys,
Something to share which will ensure the FFG moves more freely when car is on it's wheels.
You can use B74RS bearing + 1mm shim (ensure diameter is small enough to fit into rectangle cutout)+ ST08 nut instead of P31.
Some material may need to be removed from the right side steering link ball cup to ensure it does not rub on the bearing.
This solution also allows for tightening without the fear of stripping P31.
I have track tested this solution and found the FFG system needs less attention.
mmm very clever mod..had no problems at all with FFG but will try this for next meeting.
About the PTFE tape. I didn't have any to hand so I used a piece of foil backed plastic - a Kinder chocolate bar wrapper - and backed it with thin double sided tape. Then Tamiya AW grease top and bottom of the gearbox. Free movement, no wear. Works perfect.