Originally Posted by
billdelong
Check out this build thread here:
http://www.petitrc.com/reglages/asso...yPhalen_Build/
Take note on step 49... there are different arm mounts with different dot height markers... this will allow you to adjust pro/anti-squat... if you're using dots that bump up the height of the rear arms too high, this might effect your ability to control your ride height possibly, perhaps you can swap out the arm mounts?
Any chance you happened to swap the front rear shock towers by mistake?
I've used the recommended "0 dot" arm mounts for this and the build is correct for the rear arms. According to the chart, this "recommended" "0 dot" setup equates to a flat standard roll center. Yes and good question regarding the front and rear shock towers. I checked and double-checked that they are installed in their correct locations.
If I disconnect the shocks, then the wheels can travel downward far enough to give the 5mm ride height and more. I've checked the shock builds and your recommended 62mm length, so they must be correct. I'm perplexed.
Any other suggestions. I've put 2 pics in my album, but I don't know if you can view them or not.
Thanks,
JB