Originally Posted by
wisconsinbasher
so im installing a ko rsx one10 low pro servo in my new rb6 and when i turn to the right the ball cup on the servo arm is hitting the rack before full throw. i have tried switching the arm to one notch right but that throws the centering all off. i also checked to make sure i have 1 mm gap inbetween the two steering rack ballstuds. any one run into this small problem or am i just trying to get to much steering am i corect in asuming the knuckles shuld touch the casterblcks on full steering?
also can any one steer my in the right direction for a good setup for a medtraction small tight track lots of 90 corners any help would be apreciated thanks
You need to snip a piece off the ballcup as described in the manual. Cheers,