That's what I did as well. But changes I made to suit my driving: Xray 30wt all around. 2 holes closed in front and all open in back. I set my front wheel toe to 0 and I used the 1 degree caster clips in the front hindge pin holders to give the pins 1 degree toe out. I also didn't max my wheel base. It's stock length at 258mm. Droop is at 1 in front and 5 in back. This set up lays it down for stock and 19T. The 350 chassis is a must for carpet.
A Josh tip: Cut off the unused outer holes on the steering/servo saver block. This usually hits the bulk heads during hard hits and will keep you from breaking steering blocks.