Originally Posted by
plumbhard
Appreciate the advise there
CORRECT that is what is says on the batteries
Not to sound overly dumb here but if they are not meant to be hooked up together for charging why does the charging leads have three wires + & - & balance plug joined onto loop lead ?
The batteries only have + & - connection points on them, they are not like my other LIPO sticks for both SC trucks with a small earth connection in between the + & - with balance plug already connected
You appear to be on the right track. 5.0A - 7.4v (2S) is the correct setting.
Does the balance connector from the battery have 3 wires, including to the main positive and negative? Something like this?
Are the batteries also used? Do you have any way to check the voltages? Each saddle should be between 3.0V and 4.2V. If lower than 3V most chargers will refuse to charge because of possible damage to the cell and thus a safety concern. (Actually it should be even higher for a good cell at rest, at least 3.6~3.7V or so)