Originally Posted by
kevinpratt823
Well you all pretty much covered most of the ways I have dealt with this, but I will add the semi-obvious: When using a cutoff wheel to make the notch, a smaller diameter, or worn down wheel will have much less tendency to cut too far out into the chassis when cutting the necesarry depth.
Now, I would like to envite you all to use a term that I have coined/created that describes the particular syndrome which typically causes these afflictions........
Crankititis-n./(Crank-a-ti-tis) A condition in the mind and wrist that causes one to tighten bolts or screws to the point that attempted removal typically causes some form of breakage or stripping, and subsequent swear words. Also known by it's original name of Crankitootightinitis.
I too suffer from Crankititis.
Your Welcome.
Nice work man
, I concur.
Might wanna throw in "tumuchaloktite"(to-much-a-lock-tight)