Originally Posted by
RCBuddha
I believe that as long as you tighten the nut so that the adapter is centered, it should be no issue. You could also try putting some small diameter fuel tubing to help center it. I did notice what your describing on a spare MIP AE top shaft that I have on hand.
I tried the Speedtech hub, and it requires a bit of filing.
Yea i was imagining exotek hub may be able to get pinned down nicely to the avid via the diameter in the back of the plate. I took off the kyosho brass spacer and thought i could push the hub up onto that thicker part of shaft (and then figure out how much to shim remainder of where brass spacer once was), however the hubs inside diameter in back of the plate was too small to get on the shaft and would require it to be bored out to 5mm (i think). And without getting it dead center would result in wobbly spur. So im gonna wait till march for the rb6 specific hub.