R/C Tech Forums - View Single Post - lipo not fully charging?
Thread: lipo not fully charging?
View Single Post
Old 02-03-2014 | 12:46 AM
  #14  
ovalracer1m's Avatar
ovalracer1m
Tech Master
iTrader: (29)
 
Joined: May 2006
Posts: 1,173
From: Alexandria, MN
Default
Originally Posted by smokinu
Please dont set your cut off to 2.8v a cell dropping a lipo under 3.0v a cell can damage them and in some cases start fires.
The OP asked for a answer to a possible early cutoff. I gave an answer to known LVC inaccuracies. It's not a case of it cutting off at one voltage them all of a sudden another. Just inaccurate on the way safe side.
I agree with you, but if you seen where I said "the LVC may not be accurate, so you may have to set it at 2.8 to get a 3.1 cutoff". Didn't say It was a right decision for all, just what I find I and many others do to get a accurate cutoff. May have to test your exact application to see where you have to be.
Last edited by ovalracer1m; 02-03-2014 at 12:57 AM.
ovalracer1m is offline  
Reply