Originally Posted by
DBL15
It must have been to tight
Even with the o rings in stalled you need to not tighten the screws down the tank needs to be loose and have movement up and down I have found
I have removed the o rings and run 10mm of fuel tube and then longer screws so the tank can flex on the fuel tube
Good news is though the fuel tanks are in stock at Tekno though.
Orings installed. Didn't feel overtight. I made sure there was a little wiggle. This is my second tank. First one, the clunk kept falling off, and then it cracked. The new one broke with one tank through it... Just a little frustrated.