Originally Posted by
snuvet75
So what would you do if the diff cases don't flash to each other?
the amount of reuse ability of the actual cases is my biggest gripe but as two of the offending cars were second hand may bee that was the root cause.
make sure that the screws haven't pulled proud leaving a raised edge....relieve the bur with a small drill tip
grease the oring,,,,Oring grease is what i use but it makes a difference. The different density of the to liquids keeps them apart and stops the oring from pinching
try to put the screw back into the same thread and not strip them out....the nature of the self tapers is pretty vicious....pretty much the same and finally
a new diff case aint that dear so i at times put the old gears in new
case....problem solved
tell us how you go.....