Originally Posted by
Stano71
I managed to work it out with the help of the above post and have FS-gt3c working with VRC Pro perfectly, simple solution as above but mine did not come with extra cables so I just used a spare usb socket from old pc and connected green wire to tip of 3.5mm jack and black wire to earth of 3.5mm jack then plugged the 3.5mm jack into my Saili generic simulator and set it up on (g4,g5) (switch on side selects setting for different games, found this position works best) then connect other end with normal usb cable to transmitter... . Plug SAILi simulator into pc and let drivers load then just calibrate in windows game controller and you are ready to go.
Thanks very much for your post, I found another way using your same method where my radio didn't come with all the extra cables either:
1) Cut off the DSC 3.5mm connector, then splice into the coax and separate the braided strands and twist them into a single wire, then strip the lead off the yellow wire
2) Cut off the Male end of a sacrificial Mini-USB cord, then splice into the coax and separate the braided strands and twist them into a a single wire, then strip the lead off the white wire
3) Connect the White wire to the Yellow wire, then connect both ends of twisted braids
4) Connect custom cord to PC + Radio, then turn on the radio and then the drivers will automatically install
5) Launch VRC, go into game settings, calibrate, then reverse the throttle
